Difference between revisions of "AY Honors/Welding"

From Pathfinder Wiki
< AY HonorsAY Honors/Welding
(Bot: Automated import of articles *** existing text overwritten ***)
m
 
(4 intermediate revisions by 2 users not shown)
Line 4: Line 4:
 
|category=Vocational
 
|category=Vocational
 
|authority=North American Division
 
|authority=North American Division
−
|insignia=Welding AY Honor NAD.png
+
|insignia=Welding (NAD) AY Honor.png
 
|instructor=qualified
 
|instructor=qualified
−
|overview=
+
|complete_course=true
 +
|cnt_answerKey_variants=2
 +
|answerKey_1=;;1
 +
|answerKey_2=;;2
 +
|cnt_requirements_variants=2
 +
|requirements_1=GC
 +
|requirements_2=NAD
 +
|complete_course=true
 +
|master1=Technician
 
}}  
 
}}  
  
Line 16: Line 24:
 
{{Localize|Challenging Part}}
 
{{Localize|Challenging Part}}
  
−
{{#lst:{{#titleparts:{{PAGENAME}}|2|1}}/Requirements{{GetLangSuffix}} |challenge}}
+
{{#invoke:HonorChallPart|getChallengingPart}}
 
{{CloseHonorPage}}
 
{{CloseHonorPage}}

Latest revision as of 14:48, 11 February 2022

Other languages:
English • ‎español • ‎português do Brasil
Welding

Skill Level

3

Year

1978

Version

27.11.2024

Approval authority

North American Division

Welding (NAD) AY Honor.png

Welding
Vocational
Skill Level
123
Approval authority
North American Division
Year of Introduction
1978
See also
Technician Master Award

Overview

The Challenging Part

The most challenging requirement of this honor is probably this:

10. Demonstrate ability to weld flat, vertical, horizontal, and overhead on (1/8 inch x 1 inch x 8 inches) (0.3 cm x 2.5 cm x 20.3 cm) mild steel test plates.

11. Using the designated processes, perform the following:

a. PAC: Make one straight cut at least three inches long in mild steel or aluminum

b. SMAW: Complete i and ii, or complete iii.

i. Make two bead-on-plate welds at least two inches total length

ii. Make one square-groove weld in the flat position

iii. Make one corner weld in the flat position

c. GMAW: Complete i and ii, or complete iii.

i. Make two bead-on-plate welds at least two inches total length

ii. Make one square-groove weld in the flat position

iii. Make one lap weld in the flat position

Retrieved from "https://wiki-pathfindersonline.designerthan.at/index.php?title=AY_Honors/Welding&oldid=565498"