Difference between revisions of "AY Honors/Welding/en"
From Pathfinder Wiki
< AY HonorsAY Honors/Welding/en
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
| Line 20: | Line 20: | ||
{{Localize|Challenging Part}} | {{Localize|Challenging Part}} | ||
| − | {{# | + | {{#invoke:HonorChallPart|getChallengingPart}} |
{{CloseHonorPage}} | {{CloseHonorPage}} | ||
Revision as of 01:23, 1 August 2021
Welding
Skill Level
3
Year
1978
Version
25.11.2024
Approval authority
North American Division
_AY_Honor.png)
Overview
The Challenging Part
The most challenging requirement of this honor is probably this:
10. Demonstrate ability to weld flat, vertical, horizontal, and overhead on (1/8 inch x 1 inch x 8 inches) (0.3 cm x 2.5 cm x 20.3 cm) mild steel test plates.
11. Using the designated processes, perform the following:
- a. PAC: Make one straight cut at least three inches long in mild steel or aluminum
- b. SMAW: Complete i and ii, or complete iii.
- i. Make two bead-on-plate welds at least two inches total length
- ii. Make one square-groove weld in the flat position
- iii. Make one corner weld in the flat position
- c. GMAW: Complete i and ii, or complete iii.
- i. Make two bead-on-plate welds at least two inches total length
- ii. Make one square-groove weld in the flat position
- iii. Make one lap weld in the flat position
Categories:
- Pages using DynamicPageList3 parser function
- Category:Has insignia image
- AY Honors/Complete a Course/en
- AY Honors/Secondary
- AY Honors/HonorLanding/en
- AY Honor Categories/Vocational/en
- Category:AY Honors/Vocational
- AY Honors/Introduced in 1978/en
- AY Honors/Skill Level 3/en
- AY Honors/Approved by North American Division/en
- Uses HonorLanding Template
- AY Honor Config/Has Requirement Variants
- AY Honor Config/Has Answer Key Variants
- Missing Localization/All/Welding (NAD) AY Honor.png/en
_AY_Honor.png/en&action=edit&redlink=1){kind=link}